Had to move the copper tube to my fridge a little and it caused a leak at the compression nut / sleeve, can't tell which. I can wiggle it and get it to barely drip but it still is. I tried to loosen the compression nut and check it out but I can't get it to budge. Is there a trick I don't know? I looked up videos and everyone says saddles suck anyway, so should I cut the pipe and put on a sharkbite tee stop valve? Or can I remove the saddle and somehow seal the pinhole, repair the compression area, then move the saddle to a different spot on the copper pipe? Note: I do not have equipment to solder.https://ift.tt/30wmuNR via /r/DIY https://ift.tt/38lIzSf
