I installed a shelf recently. I had a upside down chamfer on the 3/4" edge of the boards, but now that everything is mounted, not everything lines up. (think " 7 " shape on the edge of the shelf ~ 15 degrees off of a right angle)I have a router (Bosch), but there isn't enough room for me to use the router + any bits I have in an upside down position, and I've no 3/4" dovetail bits to use the router right side up.Any recommendations for how I can salvage this setup & chamfer the edges by hand? Some sort of jig + a hand plane? via /r/DIY http://bit.ly/2N6qLRF
