I finally had time to finish off my desk top, and I figured epoxy would look best. I made sure to mix the System Three MirrorCoat very well and to the correct ratio of 2:1 using the right amount for the surface area of my table.As my table was drying, in the light I noticed cloudiness in the epoxy, and I figured it would go away when dried. It is cured now, and it has not gone away. I tried wiping the table with dish soap and a cloth, but it only made the cloudiness more apparent.There were two areas on the table I used a blowtorch to remove a few bubbles, and on those areas, there is no cloudiness and it is completely clear.ImagesThe whole table has this ugly pattern that is very visible in the light. http://ift.tt/2oQI6oC this spot, I used the blowtorch for a little too long, but it is completely clear in the light. http://ift.tt/2p224Zw the epoxy were layers of Zinsser SealCoat dried months prior, but I don't think that would affect anything. What did I do incorrectly? via /r/DIY http://ift.tt/2qlRpgk
