I’m wainscoting the bathroom with some simple pre-notched baseboard, chair rail and some beadboard panels. I’ve installed the baseboard, but the place where the floor meets the tile isn’t a 90 degree angle.So there’s no way for the panel to be even with the tile portion of the wall and seated in the baseboard notch. So I’m forced to either have a 1/4” gap along part of the tile/panel section or the panel would be about 1/4” above the baseboard.At this point I’m leaning toward pulling this baseboard up, hanging the panels level and then getting a larger baseboard and just putting it over top.Am I missing some obvious solution? via /r/DIY http://bit.ly/2AXjWNj
