Hi guys, sorry in advance if i'm posting this in the wrong place. I spent this morning putting together a table for my new place, but with all the parts put in place I've found that there's a decent amount of wobble to it - not the wobble of the legs being uneven but more like the screws attaching the skirt/apron and legs are pushing and pulling.The legs are definitely looking a bit dainty compared to the top but I'm hoping with the correct bracing I can overcome that! I would definitely appreciate any advice on the best way to stop the table from wobbling.http://ift.tt/2CrYsGr has been joined with pocket joints except the 45 degree braces which I just screwed in parallel to the crossbeams. I will eventually attach the top to the base with figure 8 screws/washers.The measurements are as follows:Top (L x W x H) 182cm x 95cm x 4.5cm Legs: 72cm, 90mm x 35mm Aprons: 126cm x 90mm x 35mm cross beams: 65cm x 90mm x 35mmAdmittedly the top is quite heavy but I'm hoping /r/DIY will have some good advice for me.Thanks! via /r/DIY http://ift.tt/2o81ZFr
