I need to build 2 drawers for my work ute (pickup) and am wanting some ideas to make them easier to pull out when loaded with tools. they will each be 1700mm long and made out of plywood, and sliding on plywood too. http://ift.tt/2yRVgSt have looked at getting some 6mm thick plastic wear strips for them to run on but they are going to cost $130 for 4 of them.I have no space on the sides for runners to be installed.I have also thought about putting some small wheels under the tail end of the drawer just to help it a bit but not sure if they will work or not. Wheels http://ift.tt/2Btzo2C Slide pads http://ift.tt/2B6jb6x have quite a tight budget for this fit out.Any helpful advice is greatly appreciated. via /r/DIY http://ift.tt/2Bsje9K
