Using Steeltek pipe fittings to create a corner railing over a half lower level. My plan was to have the uprights and top & bottom horizontal rails made from the galvanized pipe & fittings and use cable rail for the in between horizontal rails.I'm trying to figure out the best way to run the cable through the corner post so I can use the two outside posts as terminals. My concern is that I want to alleviate any kinking/scraping of the cable as it makes that turn and is tensioned.My little drawing: .--. .--. / \_____________________/__ \ \ / \ | / '--' '-|' | | | | .--. / \ \ / '--' via /r/DIY http://ift.tt/2uwEB9S
