I got a new power rack from body solid. For those of you who have no clue what that is, it's basically a big steel frame 4x4x7' that is used for weight lifting. It's a big 3D rectangle made of steel. When standing upright, there is one bar removed which allows you to enter it without stepping over a bar.What happened is the instructions say to not tighten any bolts until the very end when all prices are loosely put together. I did that. After everything was properly put into place I tightened it all up. I started at the base on the floor and went around the entire rack a couple times tightening them a little bit at a time.Now the rack is all put together, sturdy, but the vertical bars are all leaning to the left slightly. It is sturdy enough to use but it is clearly slanted to the naked eye.I've since tried backing off all of the bolts a little to maybe take some of the stress off the joints to see if I can level it out, and it did a bit, but it is still leaning. Does anyone have any tips on how to identify which joint is possibly messing me up, or what to look for? Any help would be appreciated. via /r/DIY http://ift.tt/2lS4pYE
