As the title states, I have a table saw that went through a floor. Unfortunately at the time of the flood it never occurred to me to try and salvage the saw until much later. It’s been 6 months in the garage which has been a semi dry environment.My question is whether the internal parts ( shaft, motor, windups, etc) are susceptible to rust, and if anyone can suggest steps to restore the table saw?Research indicated I need to take the motor apart to check for any rust on the windings and rotor. The windings may not be a big issue, but the rotor looked. Bit more difficult to diagnose.I’m wondering what the repercussions would be if I did a dry run test (just turning it on to see if it even works) and go from there. Is it safe to run? If it actually runs, is it safe to not disassemble? via /r/DIY https://ift.tt/2TdsZ2R
