I've got a problem with a new circuit that I ran from my panel. Here are the details:- Breaker is 20 amp AFCI- The first receptacle on the circuit is a 15 amp GFCI- In one direction from the GFCI, there is a single pole switch that controls a single light fixture. Light works as expected when breaker is on.- In the other direction, there are four 15 amp receptacles, pig-tailed (wired as pictured in the image)When I use my circuit tester on the receptacles, the GFCI and the first two receptacles read as Correct. The last two on the circuit read as Open Neutral.I've checked the connections on the last two receptacles and they all seem good. I've also swapped out the receptacles for new ones to eliminate an issue with the receptacles themselves. They still both read Open Neutral.I also went out and got a new GFCI circuit tester to rule out an issue with the tester. Its this one:http://bit.ly/2EKl9Ks question: can the open neutral issue be anywhere on the circuit, even though the first few receptacles read as Correct?EDIT: Sorry, my image of the circuit wiring didn't work. Here's a link:http://bit.ly/2EOOpAO via /r/DIY http://bit.ly/2RdiQq5
