Good evening /r/DIY,I want to mount some hooks on the inside of my garage but instead of being smooth brick it’s the complete opposite. I am using a hammer drill (not SDS) with a 6mm masonry drill bit.Brick: https://ift.tt/2J4y610 https://ift.tt/2LNSTYL Attempt: https://ift.tt/2J2qrQW drilled the first hole at the top into a flat part and it went ok but crumbled a bit either side. How could I have stopped the crumbling?The second hole at the bottom was where I had major problems, the grooves in the brick are less that 6mm so when I put the masonry bit inside and started to drill the tip of the bit sheared off pretty much instantly.How would you complete this task?Thanks in advance. via /r/DIY https://ift.tt/2LMlZaE
