Our soapdish was broken by someone dropping the shower head and smashing it into the soapdish. When I removed it, I found it was essentially glued in to place on a wire mesh pattern seen in the picture linked below. I believe they just used a ton of silicon caulking to hold it as there is maybe a quarter inch gap between the wall and back of the soap dish. Should I just mount the replacement in the same way or is there a better way to fill in the gap behind the dish and the wall for this repair. It held for 20 years and would still be there if not broken but this doesn't seem at all the normal way to mount a soap dish.http://ift.tt/2wMP8Pr via /r/DIY http://ift.tt/2fKmLXx
