Type something and hit enter

ads here
On
advertise here

For my current house-exterior painting project, I've acquired a few pieces of power-painting equipment that haven't always been properly cleaned. I'd like to properly clean the guns, valves, and nozzles after this job, and it seems to me that a parts washer would be just the thing.I'd use lacquer thinner, but that's mostly acetone, which has a very low flashpoint (about -4F, apparently). My parts washer says not to use any solvent with a flashpoint below 100F.Is there a solvent that I can safely use with the parts washer to clean up my spray guns? via /r/DIY http://ift.tt/2wyyaU6

Click to comment